Instruction sheet
10532027
23SE13 REV2
NOTICE - Only licensed Remy International, Inc. product and component parts should be used, and the use of other parts or modifications not approved
by Remy International, Inc. will void all applicable warranties. The failure to carefully follow these Installation Instructions, set forth above, will void all
applicable warranties. DELCO REMY is a registered trademark of General Motors Corporation, licensed to Remy International, Inc. Pendleton, IN 46064.
© 2012 Remy International, Inc. All rights reserved 1
Technical support: USA 800 854 0076, Mexico 01 800 000 7378, Brazil 0800 703 3526, South America 55 11 2106 6510 or visit
delcoremy.com
37MT™ & 41MT™ SIDE GROUND TERMINAL REPLACEMENT INSTRUCTIONS
This ground terminal replaces one of the pole shoe screws on starter models that require a ground terminal on the side of the
frame.
WARNING!!! ALWAYS USE PROPER EYE PROTECTION WHEN PERFORMING ANY MECHANICAL REPAIRS TO A VEHICLE –
INCLUDING, BUT NOT LIMITED TO, ANY INSTALLATION AND OR REPAIRS TO THE DELCO REMY STARTING MOTORS.
FAILURE TO USE PROPER EYE PROTECTION CAN LEAD TO SERIOUS AND PERMANENT EYE DAMAGE.
Only perform the mechanical functions that you are properly qualified to perform. Mechanical repairs that are beyond your technical
capabilities should be handled by a professional installation specialist.
FOLLOW ENGINE AND/OR VEHICLE MANUFACTURER'S INSTRUCTIONS CAREFULLY WHEN REMOVING AND INSTALLING
THE STARTER.
DANGER!!! ALWAYS DISCONNECT BATTERY GROUND BEFORE REMOVING OR REPLACING CABLES AT THE STARTER.
FAILURE TO DISCONNECT THE BATTERY GROUND CABLE CAN LEAD TO SERIOUS INJURY.
PROCEDURES FOR REPLACING OR CHANGING THE LOCATION OF THE SIDE GROUND TERMINAL
1. Remove vehicle leads connected to the starter, noting their positions for reinstallation, and remove starter.
2. Remove and dispose of the side ground terminal.
3. Install new side ground terminal and torque to 20.3-27.1 Nm (15-20 lb ft).
4. If changing location of the side ground terminal, remove a pole shoe screw from the desired location and exchange places with the
parts. Check the condition of sealing features and consider replacing with new part assemblies if damaged or excessively worn.
5. Install the pole shoe screw and torque to 20.3-67.8 Nm (15-50 lb ft).
6. Install the side ground terminal and torque to 20.3-27.1 Nm (15-20 lb ft).
7. Reinstall starter and connect cables and other leads, as removed.
8. Reconnect the negative (-) cable at the battery
(4 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals